Verify that the IDE device is set up as Auto or CD Drive. Once connected, turn on the computer and enter BIOS setup. If you experience problems, you may have to disconnect all the cables again.) (We recommend you do not connect all the cables yet. Connect the keyboard, monitor, and power to the computer. Once the disc drive is connected to the computer, place the case back on the computer.
The audio cable will connect to one of the following locations: sound card, motherboard (when onboard sound present), or DVD decoder card. Once the cables are connected to the drive, connect the opposite ends of the IDE/EIDE interface cable and the audio cable to their appropriate locations. This cable is keyed, therefore it should only connect to the computer in one orientation. This side of the cable often points to where the power connects to the CD-ROM drive.įinally, connect the Molex style power cable to the back of the CD-ROM drive. This cable has one side of the cable that is red or blue indicating PIN 1. Next, connect the 40-pin IDE/EIDE interface cable (large gray ribbon cable) to the back of the CD-ROM drive. While it may be possible for the cable to connect to these pins, this could cause additional issues. Make sure you are connecting this cable the cable plug and not the jumpers on the back of the drive. When connecting this cable to the CD-ROM drive, it should be a 3 or 4 pin cable connection (see above picture). The CD-ROM should have two cables connected to it and may have an audio cable, which is the smallest of the cables. Having the drive as the primary helps prevent buffer underruns when creating a CD. We recommend when installing a CD-R or CD-RW drive that the drive be set up as the primary drive on the second IDE/EIDE interface.
0 kommentar(er)
